Plantronics R-410A Instrukcja Użytkownika Strona 6
- Strona / 26
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
1. Before fixing the installation plate to a wall, you must determine the position of the 2
3
/
4 in (70 mm) hole through which
the conduit, piping and drain hose pass to connect the indoor unit to the outdoor unit. The piping and conduit can be con-
nected from the: Rear, Right or Left side of indoor unit.
2. Determine the position of the pipe and drain hose hole using one of the figures shown, and drill the hole with an inner
diameter of 70 mm (2
3
/
4 inch) so that it slants slightly downwards.
3. The correct mounting of the indoor unit is as shown below.
CORRECT
INCORRECT
POSITION THE MOUNTING PLATE LEVEL
CORRECT
INCORRECT
INCORRECT
Right side 2 in
minimum
Left side 2 in
minimum
59 to 79 in
minimum
59 in minimum
2 3/8 in minimum
Caution:
Take servicing into consideration and leave the spacing shown in the figure above. Also install the unit where
it can be removed.
Installation & service manual _3
INSTALLATION RECOMMENDATIONS (INDOOR UNIT)
- This system uses 1
- CONTENTS 3
- SAFETY CONSIDERATIONS 4
- ACCESSORIES 5
- INCORRECT 6
- Air inlet 7
- ELECTRICAL INSTALLATION 8
- 3 2 1L1 N 9
- WIRING SYSTEM DIAGRAMS 10
- 3 2 1L1 L2 10
- INDOOR UNIT 11
- OUTDOOR UNIT 11
- Indoor unit 12
- Outdoor unit 12
- SYSTEM EVACUATION 15
- GAS LEAK CHECK 17
- Auxiliary control button 18
- TECHNICAL SPECIFICATIONS 19
- OUTLINE AND DIMENSIONS 20
- PARTS DIAGRAM (INDOOR UNIT) 21
- PARTS LIST (INSIDE UNIT) 22
- PARTS DIAGRAM (OUTDOOR UNIT) 23
- PARTS LIST (OUTSIDE UNIT) 24
Komentarze do niniejszej Instrukcji